1963-74 Corvette Undercar Chambered Exhaust

Made from 2-1/2" aluminized 14ga. tubing, the 1963-74 Corvette undercar chambered exhaust ships with all clamps and gaskets necessary to bolt, right on.

Systems may be ordered with 2-1/2" inner chamber diameter for all out performance or 2-1/4" for a milder sound.

Mild or Wild priced the same.

The test vehicle utilizes a mono-leaf spring with plenty of clearance, factory original stacked springs have even more room.

Each system comes with a chamber crosslink to further control the system position.

Rigid rubber grommets hang the rear assembly utilizing one of the anti-sway bar mount hole

For maximum flow we offer a 2-1/2" or 2-1/4" polished stainless tips. Due to the smaller bezel diameter it is suggested the 63 models use 2-1/4" tips.

The picture shown here represents the tight fit of a 2-1/2" tip in a 63 bezel.

The rear view shows the tight smooth fit of the tail pipes into our 1963 test valance.

Our "Two-Tone" side exhaust 1965 Corvette goes through the paces as we test each undercar design.